Recall Of Stored Programs; Leaving Program Mode; Starting And Stopping The Centrifuge; Starting The Centrifuge - Hermle Z 216 MK Operating Manual

2.5.2 Recall of Stored Programs

To recall stored programs, press the key "prog" (11), with the lid already closed. Inside the display
"time" (A-3), appears "programm --"(M10). With the adjustable knob (1), pre-select the desired
program number.
In the respective displays, the stored values, for that program, will appear.
If there is not the correct rotor inside the centrifuge, for the pre-selected program, in the display
"rpm/rcf" (A-1) flashes the word "rotor" (M3). At the same time, the word "FALSE" and the stored
rotor number "22x. xx""(M4) flash in sequence of one another.
For all number marked text, please refer to Figure 28.
Figure 28

2.5.3 Leaving Program Mode

o leave the program mode, press the key, "prog" (11). Then, inside the display "time", appears the
word "programm".
Set the display to "programm--" (M10) with the adjustable knob (1).
For all number marked text, please refer to Figure 28.

2.6 Starting and Stopping the Centrifuge

2.6.1 Starting the Centrifuge

Start the centrifuge with either the "start" key (9), or the "quick" key (8).
With the "start" key (9), stored runs or runs with manually pre-selected parameters can be started.
When the respective pre-selected running time has ended, the centrifuge will stop automatically.
With the "quick" key (8), start runs, which will last a few seconds, can be initiated.
By pressing the "quick" key (8), the centrifuge accelerates up to the pre-selected revolution.
In the display "time" (A-3), the passed running time is indicated from the moment the "quick" key (8)
is pressed.
By releasing the "quick" key (8), the centrifuge stops and the running time is indicated, until the lid is
opened.
For all number marked text, please refer to Figure 28.
© Hermle Labortechnik GmbH Z216MK_V1.19_eng
OPERATION
25