Advertisement
Transport
Lock
Figure 3-4: Transport Lock Engaged
7. Connect the 7-Pin Connector to Tractor Outlet,
routing cable by avoiding pinch points.
•
Make sure the tractor has a good clean
receptacle, free of dirt and corrosion.
•
Make sure the 7-Pin Connector is inserted ALL the
way in. With tighter fitting pins, operator may think
the Connector is all the way in, but really isn't.
•
Make sure the tractor receptacle cover latches
over the keyway on the 7-Pin Connector to hold
the Connector in place.
•
If an operator plugs in the 7-Pin Connector, but
the lights do not seem to work right, check the
above items to make sure there is a good
connection with the 7-Pin Connector.
Attaching/Detaching Pull Type
Till 'N Seed
Attaching the Till 'N Seed for Field
Operations:
Till 'N Seed is parked lowered
1. Attach the Till 'N Seed to the Tractor.
2. Raise the Till 'N Seed fully to extend the Hydraulic Lift
Cylinders and rotate the Transport Locks in the
engaged position over the Cylinder Rod. Secure with
the Clevis Pins and Hair Pin Cotters. See Figure 3-4.
3. Raise and rotate Jack to stored position before setting
the machine in motion.
4. Transport the Till 'N Seed to the area to be seeded.
F-1097-2305
TABLE OF CONTENTS
Hydraulic
Cylinder
Clevis Pin,
1/2 x 4
Hair Pin
Cotter
Rockshaft
Wheel Arm
5. Disengage each Transport Lock so the Transport
Lock rests on the Wheel Arm. Secure with Clevis Pin
and Hair Pin Cotter into the Wheel Arm Tab. See
Figure 3-5.
Till 'N Seed is parked raised
1. Attach Till 'N Seed to the Tractor.
2. Raise and rotate Jack to stored position before setting
the machine in motion.
3. If not already done, raise Till 'N Seed fully and engage
Transport Locks. See Figure 3-4.
4. Transport the Till 'N Seed to the area to be seeded.
5. Disengage each Transport Lock so the Transport
Lock rests on the Wheel Arm. Secure with Clevis Pin
and Hair Pin Cotter into the Wheel Arm Tab. See
Figure 3-5.
Detaching the Till 'N Seed:
Parking Till 'N Seed lowered
1. Raise the Till 'N Seed fully to extend the Hydraulic Lift
Cylinders and rotate the Transport Locks to the stored
position. Secure with the Clevis Pins and Hair Pin
Cotters. See Figure 3-5. Lower the Till 'N Seed,
relieve pressure from Hydraulic Hoses.
2. Rotate and Lower Jack.
3. Disconnect the Tractor from the Till 'N Seed.
Parking Till 'N Seed raised
1. Raise the Till 'N Seed fully to extend the Hydraulic Lift
Cylinders and rotate the Transport Locks to the
locked position. Secure with the Clevis Pins and Hair
Pin Cotters. See Figure 3-5.
2. Relieve pressure from Hydraulic Hoses.
3. Rotate and lower Jack.
4. Disconnect the Tractor from the Till 'N Seed.
Hydraulic
Cylinder
Wheel Arm
Tab
Hair Pin Cotter
Figure 3-5: Transport Lock Stored
OPERATION
Transport
Lock
Clevis Pin, 1/2 x 4
3-5
Advertisement
