Advertisement
OPERATION
Attaching/Detaching 3-PT Hitch
Till 'N Seed
WARNING
To prevent the implement from tipping forward on
the frame, disengage parking stand only when the
seeder is fully attached to the tractor. Be sure to
observe the following sequences.
Hooking Up the Till 'N Seed:
1. Attach the Till 'N Seed to the tractor. Raise the
Seeder.
2. Raise Parking Stands by removing each Parking
Stand 3/4" Pin and lifting the Parking Stand until the
bottom hole is aligned with the bracket hole. Replace
the 3/4" Pin. See Figure 3-2.
3. Remove both 3/4" Rear Roller Locking Pins from the
Frame LH and RH End Plates and place them in the
Toolbox. See Figure 3-3.
Unhooking the Till 'N Seed:
1. Raise the Till 'N Seed. Lower Parking Stands by
removing each Parking Stand 3/4" Pin and lowering
the Parking Stand. Align one of the three holes with
the bracket hole depending upon the site ground,
replace the 3/4" Pin. See Figure 3-2.
2. Both sides, insert 3/4" Rear Roller Locking Pins into
the Frame LH and RH End Plates to lock the Rear
Roller Arm. See Figure 3-3.
3. Lower the Till 'N Seed and disconnect the tractor from
Seeder.
Parking
Stand
Drive Rotor
Figure 3-2: Parking Stand
3-4
TABLE OF CONTENTS
Tractor Preparation for Attaching
Pull Type Till 'N Seed
Do not allow any bystanders to stand between the
tractor and the implement while backing up to the
implement.
1. The Till 'N Seed is designed to be used with a
2. Align the Tractor Drawbar with the machine. Raise or
DRAWBAR CAT
Parking Stand
3/4" Pin
3. Raise and rotate Jack to stored position before setting
4. Clean all hydraulic couplings and attach to the tractor.
5. Attach Safety Chain to tractor allowing plenty of
6. If Transport Locks are not engaged, fully extend the
Frame
3/4" Rear Roller
Rear Roller Arm
Figure 3-3: Rear Roller Locking Pin Engaged
DANGER
DANGER
Category 2 Drawbar Hitch.
lower the Drawbar Hitch as needed using the Jack.
Attach the unit with proper size Hitch Pin and Safety
Clip. See Table 3-1.
Min Pin Size
2
1-1/4" (30mm)
Table 3-1: Pin Size
the machine in motion.
movement for turning both directions. The Safety
Chain should latch securely to prevent it coming
loose. See "Safety Chain" on page 1-4.
hydraulic lift cylinders and rotate Transport Locks in
the engaged position over the Cylinder Rods. Secure
with the Clevis Pins and Hair Pin Cotters. See
Figure 3-4.
Locking Pin
Max PTO HP
154 (115 Kw)
F-1097-2305
Advertisement
