Advertisement
ASSEMBLY
Rockshaft Installation
1. Loosen RH and LH Lift Mount Hardware so that they
can be slid onto each end of the Lift Rockshaft
Assembly. See Figure 2-3.
2. Center the Lift Rockshaft Assembly on the back of the
Till 'N Seed Frame between the RH and LH Lift
Mounts.
3. Place a Nylon-Thrust Ring and a UHMW Bearing on
each end of the Lift Rockshaft 4-1/2" Tube. Nylon
Thrust Ring must be against the Lift Rockshaft
Assembly Thrust Ring.
4. Align the Lift Rockshaft Tube with the RH and LH Lift
Mounts. Slide the Lift Mounts over the UHMW
Bearing on the Lift Rockshaft up to the Nylon Thrust
Ring.
Pin,1 x 5-1/16
Flat Washer,1"
Roll Pin,
5/16 x 2
Transport Lock
2-4
TABLE OF CONTENTS
LH Lift
Mount
Hydraulic
Cylinder,3 x 8
Hair Pin Cotter
Flat
Washer,1"
Lift Rockshaft
Assembly
Figure 2-3: Rockshaft Installation
5. Tighten RH and LH Lift Mount Hardware.
6. Install a 3 x 8 Hydraulic Cylinder Rod end along with
a Transport Lock onto each Lift Rockshaft Lug. Place
a 1" Flat Washer on each side of the Lift Rockshaft
Lug and position it between the Cylinder Clevis.
Orient the Transport Lock so that Transport Lock
opening can swing over the Cylinder Rod when
pinned. Position the Transport Lock Slots over the
Cylinder Clevis. Align and install 1 x 5-1/16 Pin. Place
a 1" Flat Washer on each end of the Pin and secure
with 5/16 x 2 Roll Pins.
7. Flip Transport Lock back to rest on the Wheel Arm
Tab. Secure with 1/2 x 4 Clevis Pin and Hair Pin
Cotter. Transport Lock is in the stored position.
Clevis Pin,
1/2 x 4
Hub and Spindle
Assembly
RH Lift
Mount
UHMW
Bearing
Nylon-Thrust
Ring
Wheel Bolts,
1/2-20 x 1
Wheel and Tire
Assembly
F-1097-2305
Advertisement
