Advertisement
Drawbar Installation
WARNING
Do not attempt to lift heavy parts manually. Use a
hoist or a fork lift to move these parts into
position.
When shipped, the Till 'N Seed comes assembled except
for the Drawbar, Lift Rockshaft Assembly, and Tire and
Wheel Assemblies
Hose Support
Bolt,5/8-11 x 2-1/4
Thick Washer,5/8
Locknut,
Flange 5/8-11
F-1097-2305
TABLE OF CONTENTS
Parking
Stand
Figure 2-2: Drawbar Installation
1. Untie the two rolled up Drawbar Hydraulic Hoses near
the center of the Frame Tube. Ensure the hoses are
not interfering with where the Drawbar is to be
attached.
2. Center Drawbar on the front Frame Tube. Attach
Drawbar to Frame Tube with 3/4-10 U-Bolts, Flat
Washers and Locknuts. See Figure 2-2.
3. Attach the Hose Support to the Drawbar with 5/8-11 x
2-1/4 Bolt, Thick Washer and Flanged Locknut.
4. Lower Drawbar Jack.
Frame
Locknut,
3/4-10
Drawbar
Assembly
ASSEMBLY
U-Bolt, 3/4-10
Flat Washer,3/4
2-3
Advertisement
