Advertisement
•
Check and adjust air pressure when machine is
raised.
•
Recommended starting Air Shock pressure is 50 psi.
Typical air pressure range for this machine is 20-100
psi. In some instances more air pressure may be
necessary, but do not exceed 120 psi. Optimal air
pressure will vary depending on soil conditions
•
Reduce air pressure on soft ground and increase air
pressure on hard ground works best.
Gauge Wheels
Gauge Wheels are adjustable to control the depth of the
Tillage Rotor. Engaging the Gauge Wheels with the
ground will also help reduce Tillage Rotor bounce.
1. Adjust the Gauge Wheels by removing the Klik Pin
and Hex Lock Clip. See Figure 3-9.
Klik Pin
Gauge
Wheel
Tube Cap Tab
Figure 3-9: Adjusting Gauge Wheel
2. Place the Calibration Crank Assembly onto the
Gauge Wheel Adjusting Screw Hex. See
Figure 3-10.
F-1097-2305
TABLE OF CONTENTS
Adjusting Screw Hex
Hex
Lock Clip
Calibration Crank
Assembly
Figure 3-10: Calibration Crank Assembly
3. Turn the Calibration Crank to achieve the desired
Tillage Rotor Depth. Use Wheel Arm Tube slots as a
guide. See Figure 3-11.
Tube Cap Tab
Gauge Wheel
Figure 3-11: Gauge Wheel Detail
4. Align the Hex Lock Clip cutouts with the Tube Cap
Tabs. Slide the Hex Lock Clip onto the Gauge Wheel
Adjusting Screw Hex and over the Tube Cap Tabs.
Secure with Klik Pin.
5. Remove Calibration Crank Assembly and place it in
the Tool Box.
OPERATION
Adjusting
Screw Hex
Gauge
Wheel
Hex Lock
Clip
Wheel Arm
Tube Slots
3-7
Advertisement
