Advertisement
ASSEMBLY
Drawbar Model Warning
Lamps Installation
IMPORTANT
Cords are marked Yellow Tape for Left and Green
Tape for Right.
1. Lay out the 7-Pin Harness along the Drawbar with the
4-Prong Connector towards Seeder. Route the 7-Pin
Harness 4-Prong Connector through the Hose
Support and Drawbar Hose Loops to the Seeder.
Connect 7-Pin Harness 4-Prong Connector to the
Lamp Wishbone Harness 4-Prong Connector. See
Figure 2-10.
2. Bundle and secure with tie wraps after Hydraulic
Hoses have been installed.
3. Connect 7-Pin Plug into Tractor and check Warning
Lamp functions.
7-Pin Harness,
2-8
TABLE OF CONTENTS
4-Prong
Connector
15Ft
Figure 2-10: Drawbar Warning Lamps Installation
IMPORTANT
All harnesses must be firmly attached to machine
frame members, so they don't sag or become torn
loose by field debris. Use the tie wraps provided.
Check to be sure the harnesses at center of machine
is slack enough so as not to be stretched or
interfered with while rotating frame from transport to
field working position and vice versa.
NOTE
The 7-Pin Harness connects to the tractor socket when in
use. When not in use, it can be stored in the Plug Holder
Cutout on the top of the Drawbar. Allow enough harness
length to reach tractor socket and roll or fold up excess
and secure to hydraulic hoses or Drawbar.
Lamp Wishbone
Harness
Drawbar
F-1097-2305
Advertisement
