Advertisement
CAUTION
Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means.
WARNING
Do not attempt to lift heavy parts manually. Use a
hoist or a fork lift to move these parts into
position.
NOTE
Refer to the repair parts manual F-1096 for identification
of parts and for the approximate relationship of the parts
in assembly. Your exact Seeder Model may vary slightly
from the illustration.
To ensure alignment of assemblies, leave the nuts loose
until completion of final assembly. Use lock washers or
flat washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts evenly
to prevent misalignment, distortion or binding. Tighten all
screws and nuts to the recommended torques.
IMPORTANT
• If pre-assembled parts or fasteners are temporarily
removed, remember where they go. It is best to keep
parts separated.
• Check that all working parts move freely, bolts are
tight and cotter pins spread.
• Refer to the Torque Table for proper torque valves.
Note the different torque requirements for bolts with
lock nuts. See "General Torque Specifications" on
page 4-1.
"Left" and "Right" refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
IMPORTANT
All harnesses must be firmly attached to machine
frame members so they don't sag or become torn
loose by field debris. Use the tie wraps provided.
Check to be sure the harnesses at center of machine
is slack enough so as not to be stretched or interfered
with while lowering frame from transport to field
working position and vice versa.
F-1097-2305
TABLE OF CONTENTS
Chapter 2
Assembly
2-1
Advertisement
