Download Print this page

Landoll Brilllion Till'N Seed BPSB-8 Operator's Manual page 29

Advertisement

Acre Meter Kit - Optional
The Acre Meter consists of three main parts: the Acre
Meter, the Pick-Up Switch and the Magnet Wheel
Assembly.
1. Install Acre Meter Angle to LH Support with 5/16-18 x
1 Flange Bolts and Locknuts. See Figure See
Figures 2-15 and 2-16.
2. Slide the Magnet Wheel Assembly onto the
Jackshaft. Secure with Magnet Wheel Assembly Set
Screw.
3. Attach the Pick-Up Switch to the Acre Meter Angle
with #8-32 x 1-1/4 Screws, Flat Washers, Lock
Washers, and Nuts. Do not tighten at this time.
4. Attach the Pick-Up Switch short ground wire to the
small hole on the acre Meter Angle with a #6-32 x 1/2
Screw and Nut. Remove paint under the wire
connector to assure a good electrical ground
connection. See Figure 2-14.
5. Adjust the Pick-Up Switch on the Acre Meter Angle so
the centerline of Magnet Wheel Assembly and
Pick-Up Switch are horizontally and vertically aligned
with maximum 1/8" between the Magnet Wheel
Assembly and the Pick-Up Switch. Tighten #8-32
Screws.
NOTE
Alignment of the Pick-Up Switch and Magnet Wheel
Assembly is critical. Improper alignment will cause the
Acre Meter to record acres erratically or not at all.
6. Attaching Acre Meter Assembly to Till 'N Seed.
Acre Meter with Micro-Meter and Large Meter
Seed Boxes.
Attach the Acre Meter Assembly to the Large
Meter Seed Box Rear Deflector with 3/8-16 x 1
Bolt, Flat Washer, Lock Washer and Nut. See
Figure 2-15.
Acre Meter with Agitator Box.
Attach the Acre Meter Assembly to the Agitator
Box Rear Deflector with 3/8-16 x 1 Bolt, Flat
Washer, Lock Washer and Nut. See Figure 2-16.
7. Connect the Acre Meter and Pick-Up Switch
Connectors.
8. Securely fasten the cords to the Till 'N Seed with tie
wraps to prevent cords from becoming entangled or
rubbing on moving parts.
9. Program the Acre Meter. See "Electronic Acre
Meter Kit - Optional" on page 3-16.
F-1097-2305
TABLE OF CONTENTS
Acre Meter
Angle
Pick-Up
Switch
Figure 2-14: Acre Meter Mounting Dimension
Pick-Up Switch
Cord
Wheel Assembly
Jackshaft
ASSEMBLY
Ground Wire
1/8"
Maximum
Magnet
2-11

Advertisement

loading