Table of Contents
Advertisement
Chapter 3
Install the Fittings on the OmniRow Hydraulic Motors
Before mounting the OmniRow hydraulic motors on the machine, install the proper fittings in the motors. This
prepares the motors for installation and simplifies the hose connection process later in the procedure. Refer to
the following table to install the fittings in the appropriate ports of the OmniRow hydraulic motors.
Fittings Installed on Hydraulic Motors
FIGURE 5.
P/N 333-0012-139
(Tank Port)
P/N 333-0012-045
(Pressure Port)
Fitting - 9/16" SAE O-Ring (M) to 9/16" JIC (M) Straight Adapter
Fitting - 3/4" SAE O-Ring (M) to 9/16" JIC (M) 90° Elbow
8
When installing OmniRow hydraulics or
performing diagnostics, maintenance, or routine
service, ensure precautions are taken to
prevent any foreign material or contaminants
from being introduced into the machine's
hydraulic system.
Objects or materials that are able to bypass the
machine's hydraulic filtration system will reduce
performance and possibly cause damage to the
OmniRow hydraulic equipment.
Fitting
John Deere Individual Row Control OmniRow Installation Manual
CAUTION
Part Number
333-0012-045
333-0012-139
Port
P
T
Advertisement
Table of Contents
