Install The Powerglide Plus Wiring; Wiring Connections; Install The Autoboom Node - Raven AutoBoom Installation Manual

Install the PowerGlide Plus Wiring

Wiring Connections

For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously
on both the male and female ends of the connectors. Application of the grease will prevent corrosion to the
pins and wires.

Install the AutoBoom Node

AutoBoom Node Installed
FIGURE 17.
Mount the AutoBoom node (P/N 063-0130-010) to the valve mounting plate using three 3/8"-16 x 1-1/4" zinc
1.
hex bolts (P/N 311-0054-106) and three 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Note:
Position the node so that the cable connections face down.
Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-045 or 115-0230-085)
2.
into the correct ports of the AutoBoom node.
Tighten the bolts on the node connectors to secure the connections.
3.
Manual No. 016-0230-039
CAUTION
Always connect the power cable as the last
step in the wiring process and verify that the
power leads are connected with the correct
polarity. Reversing power leads can cause
severe damage to the equipment.
PowerGlide Plus
23