Table of Contents
Advertisement
Install the PowerGlide Plus Wiring
Wiring Connections
For wiring connections made outside the cab, apply Dielectric Silicone Grease (P/N 222-0000-006) generously
on both the female and male end of the connectors. Application of the grease will prevent corrosion to the pins
and wires.
Install the AutoBoom Node
AutoBoom Node Installed
FIGURE 15.
Mount AutoBoom node to hydraulic valve mounting plate using supplied bolts (P/N 311-0054-106) and lock
1.
nuts (P/N 312-1001-164).
Note:
Make sure that the node is positioned so that the cable connectors face down.
Insert the two large rectangular node connectors on the harness cable (P/N 115-0230-045) into the left port
2.
of the AutoBoom node.
Tighten the bolts on the node connector to secure it to the machine.
3.
Manual No. 016-0230-012
CAUTION
Do not reverse the power leads. Doing so will
cause severe damage to the equipment.
Always check to make sure that the power
leads are connected with the correct polarity.
Ensure that the power cable is the last cable to
be connected.
PowerGlide Plus
43
Advertisement
Table of Contents
