Install The Powerglide Plus Wiring; Install The Autoboom Node; Connect The Harness To The Boom Function Controls - Raven AutoBoom Installation Manual

Install the PowerGlide Plus Wiring

Wiring Connections
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously
on both the male and female ends of the connectors. Application of the grease will prevent corrosion to the
pins and wires.

Install the AutoBoom Node

AutoBoom Node Installed
FIGURE 14.
Mount the AutoBoom node (P/N 063-0130-010) to the valve mounting plate (P/N 107-0171-802) using three
1.
3/8"-16 zinc hex bolts (P/N 311-0054-106) and three 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Insert the large, rectangular node connectors on the AutoBoom harness cable (P/N 115-0230-045 or 115-
2.
0230-085) into the correct ports of the AutoBoom node.
Tighten the bolts on the node connectors to secure the connections.
3.

Connect the Harness to the Boom Function Controls

Locate the Left Press and Right Press connectors on the AutoBoom harness cable (P/N 115-0230-045 or
1.
115-0230-085).
Route the connectors to the AutoBoom valve (P/N 063-0131-126).
2.
Connect the Left Press connector to Port G1 on the AutoBoom valve.
3.
Connect the Right Press connector to Port G4 on the AutoBoom valve.
4.
Locate the Left Solenoid and Right Solenoid connectors on the harness cable.
5.
Manual No. 016-0230-090
CAUTION
Always connect the power cable as the last
step in the wiring process and verify that the
power leads are connected with the correct
polarity. Reversing power leads can cause
severe damage to the equipment.
PowerGlide Plus
21