Mount The Gauge Wheels - Raven AutoBoom John Deere 4700 Installation Manual

Chapter 3

Mount the Gauge Wheels

Note:
Wheel mounting locations may be influenced by the boom configuration. Make sure that the
wheels will not interfere with or be damaged while folding or unfolding the booms.
Determine an appropriate location for mounting a wheel on the left boom. The wheel should be
mounted outside of the boom fold but inside of the boom breakaway.
Note:
The appearance of the wheel axles will vary, depending on the wheel axle kit that was ordered with
the AutoBoom system.
For the left wheel, attach the mounting bracket (P/N 116-0159-596) to the boom by installing the four U-bolts
1.
(P/N 107-0171-611) and securing them with the four 3/8" lock nuts (P/N 312-1001-164).
Remove the nuts from the left wheel axle.
2.
Place the wheel (P/N 322-0131-008) on the left wheel axle.
3.
Install bracket hub assembly (P/N 107-0171-617).
4.
Insert the left wheel axle into the left wheel mounting bracket by using the 1/2" hex bolts (P/N 311-0058-186)
5.
and hand-tighten the 1/2" hex nuts (P/N 312-1001-043).
Adjust wheel heights to desired spray height by loosening set bolts and moving axel in receiver tube.
6.
Tighten set bolts and lock nuts.
7.
Wheel Mounting Bracket
FIGURE 12.
Repeat these steps to install the right wheel.
8.
20
This machine must remain stationary and
switched off with the booms unfolded and
supported while installation or maintenance is
conducted.
John Deere 4700 (1998 and Older) AutoBoom Installation Manual
WARNING