Table of Contents
Advertisement
ABB i-bus
®
KNX
Mounting and installation
5.2
Mounting on mounting rail
Fig. 4: Mounting on mounting rail
1.
Place the mounting rail holder on the upper edge of the mounting rail and push down.
2.
Pull down the lower latching lever with the aid of a screwdriver or similar tool.
3.
Push the lower part of the device toward the mounting rail and let the latching lever return to its
original position until the mounting rail holder engages.
The device is now mounted on the mounting rail.
4.
Relieve the pressure on the top of the housing.
20 9AKK108467A5941 Rev. B | MG/S 11.100.1.1 | EN | Product Manual
Note about navigation in the PDF: Key combination
'Alt + left arrow' jumps to the previous view/page
Advertisement
Table of Contents
