Device X Number Of Data Points - ABB i-bus KNX MG/S 11.100.1.1 Product Manual

ABB i-bus ® KNX
Parameters
7.2.1.13

Device x Number of Data Points

This parameter is used to define the number of data points on the Modbus device concerned.
Option
0 ... 10 ... 100
Note
This parameter appears in two places:
• The General parameter window
The device parameter window
•
Changing it in one parameter window also changes it in the other.
If the Total Gateway Data Points value exceeds the maximum number of data points, the following error
message appears:
Prerequisites for visibility
38 9AKK108467A5941 Rev. B | MG/S 11.100.1.1 | EN | Product Manual
This parameter is in the General parameter window.
•
Note about navigation in the PDF: Key combination
'Alt + left arrow' jumps to the previous view/page