ABB i-bus
®
KNX
Parameters
7.2.1.9
Poll After Write
This parameter is used to activate the function Poll after write. Activating this allows the gateway to update
the new status of the corresponding KNX Group Object immediately after a write command to a server.
This parameter affects all Modbus telegrams sent by the device.
Note
After updating the KNX Group Object, the gateway goes on continuously polling the data points in
ascending order (from data point 1 to 100).
Option
No
Yes
Prerequisites for visibility
7.2.1.10
Number of Devices
This parameter is used to define the number of integrated Modbus servers.
Option
0 ... 1 ... 100
Note
Each server has its own parameter window. The parameter windows are shown or hidden depending on
the number of Modbus servers.
Prerequisites for visibility
Note about navigation in the PDF: Key combination
'Alt + left arrow' jumps to the previous view/page
The function is deactivated.
The function is activated.
This parameter is in the General parameter window.
•
•
This parameter is in the General parameter window.
Product Manual | EN | MG/S 11.100.1.1 | 9AKK108467A5941 Rev. B 35