Device X Active" Checkbox; Group Object Name - ABB i-bus KNX MG/S 11.100.1.1 Product Manual

ABB i-bus ® KNX
Parameters
7.2.2.5

"Device x Active" checkbox

This parameter is used to define whether the individual data point is activated.
Deactivated data points are taken into account in the Total Gateway Data Points parameter.
Option
No
Yes
Prerequisites for visibility
Note
The # indicates the data point number from 1 to 100.
The # is shown in the name of the corresponding Group Object.
The gateway continuously polls the data points in ascending order (from data point 1 to 100).
7.2.2.6

Group Object name

This parameter is used to specify an individual description for a Group Object. The description is shown in
the name of the corresponding Group Object.
Option
Free text entry
Prerequisites for visibility
Note about navigation in the PDF: Key combination
'Alt + left arrow' jumps to the previous view/page
The data point is deactivated.
The data point is activated.
Parameter window Config Device x \ parameter Device x Active \ option Yes.
•
• This parameter is in the Config Device x parameter window.
Maximum 64 ASCII characters; the maximum number of characters may vary for
other character formats.
This parameter is in the Config Device x parameter window.
•
Product Manual | EN | MG/S 11.100.1.1 | 9AKK108467A5941 Rev. B 45