ABB i-bus
®
KNX
Parameters
7.2.2.11
Format
This parameter is used to define the format of the Modbus register data.
If the function code (Read or Write) refers to coils or discrete inputs, the format is automatically set to "–".
The parameter can no longer be adjusted. The only situation where all options are available is for function
codes referring to registers.
Option
0: Unsigned
1: Signed (C2)
2: Signed (C1)
3: Float
4: BitFields
-
Prerequisites for visibility
7.2.2.12
Byte Order
This parameter is used to define the order in which the bytes are shown.
If the function code (Read or Write) refers to coils or discrete inputs, the byte order is automatically set to
"–". The parameter can no longer be adjusted. The only situation where all options are available is for
function codes referring to registers.
Option
0: Big Endian
1: Little Endian
2: Word Inv BE
3: Word Inv LE
-
Prerequisites for visibility
48 9AKK108467A5941 Rev. B | MG/S 11.100.1.1 | EN | Product Manual
•
This parameter is in the Config Device x parameter window.
High byte first
Low byte first
High word first
Low word first
This parameter is in the Config Device x parameter window.
•
Note about navigation in the PDF: Key combination
'Alt + left arrow' jumps to the previous view/page