Dpt; Read Function - ABB i-bus KNX MG/S 11.100.1.1 Product Manual

ABB i-bus ® KNX
Parameters
7.2.2.7

DPT

This parameter defines the KNX data point types (DPT). For a description of all the data point types
available in the ETS application, click here.
The selected DPT is shown in the name of the corresponding Group Object.
Option
7.001: pulses
x
Note
Be sure to select the correct DPT based on the associated Modbus data point.
Prerequisites for visibility
7.2.2.8

Read Function

This parameter is used to define which Modbus function codes are selected.
The function code tells the server which memory type (i.e. register, coils, etc.) to access and read.
Option
1: Read Coils
2: Read Discrete Inputs
3: Read Holding Registers
4: Read Input Registers
-
Prerequisites for visibility
46 9AKK108467A5941 Rev. B | MG/S 11.100.1.1 | EN | Product Manual
DPT 7.001
Variable for the listed data point type
This parameter is in the Config Device x parameter window.
•
• This parameter is in the Config Device x parameter window.
Note about navigation in the PDF: Key combination
'Alt + left arrow' jumps to the previous view/page