In Operation; Sending Cycle - ABB i-bus KNX MG/S 11.100.1.1 Product Manual

ABB i-bus ® KNX
Parameters
7.2.1.3

In Operation

This parameter is used to enable the Group Object In Operation. Readiness can be monitored by another
KNX device using this Group Object. If a telegram is not received, the sending device could be faulty or
the bus cable to the transmitting device could be interrupted.
Option
No
Yes
Prerequisites for visibility
7.2.1.4

Sending cycle

This parameter is used to define the cycle in which the In Operation Group Object sends a telegram.
Option
1 ... 5 ... 255 min
Prerequisites for visibility
32 9AKK108467A5941 Rev. B | MG/S 11.100.1.1 | EN | Product Manual
The function is deactivated.
The following dependent parameters are shown:
• Sending cycle
This parameter is in the General parameter window.
•
Parameter window General \ parameter In Operation \ Option Yes.
•
This parameter is in the General parameter window.
•
Note about navigation in the PDF: Key combination
'Alt + left arrow' jumps to the previous view/page