Parameters; General - ABB i-bus KNX MG/S 11.100.1.1 Product Manual

Modbus rtu, knx tp gateway

Table of Contents

ABB i-bus

KNX

Parameters

7.1

Note

ETS (Engineering Tool Software) is used to parameterize the device.

The following sections describe the device parameters based on the parameter windows. The parameter

windows have a dynamic design. The parameter windows are shown or hidden depending on the number

of Modbus servers.

The default values of the parameters are underlined, e.g.:

No (checkbox cleared)

Yes (checkbox ticked)

Note

The default values in the ETS application can vary from the values stated in the product manual

depending on the product variant.

Note

If you add 1 new device to the ETS project, 1 active data point will be shown. Data points are

configurable and can be customized for each project.

Note about navigation in the PDF: Key combination

'Alt + left arrow' jumps to the previous view/page

Product Manual | EN | MG/S 11.100.1.1 | 9AKK108467A5941 Rev. B 29

Table of Contents