Safety Messages - Emerson Rosemount 5402 Reference Manual

Reference Manual
00809-0100-4026, Rev KC
Section 6
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 149
Viewing measurement data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 151
LCD display error messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 157
LED error messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 158
6.1

Safety messages

Procedures and instructions in this manual may require special precautions to ensure the safety of the
personnel performing the operations. Information that raises potential safety issues is indicated by a
warning symbol (
performing an operation preceded by this symbol.
Failure to follow these installation guidelines could result in death or serious injury.
Make sure only qualified personnel perform the installation.

Use the equipment only as specified in this manual. Failure to do so may impair the protection

provided by the equipment.
Do not perform any services other than those contained in this manual unless you are qualified.

Explosions could result in death or serious injury.
Verify that the operating environment of the transmitter is consistent with the appropriate

hazardous locations certifications.
Before connecting a Field Communicator in an explosive atmosphere, make sure the instruments in

the loop are installed in accordance with intrinsically safe or non-incendive field wiring practices.
Electrical shock could cause death or serious injury.
Use extreme caution when making contact with the leads and terminals.

High voltage that may be present on leads could cause electrical shock.
Avoid contact with leads and terminals.

Make sure the main power to the Rosemount 5400 is off and the lines to any other external power

source are disconnected or not powered while wiring the gauge.
Antennas with non-conducting surfaces.
Antennas with non-conducting surfaces (e.g. rod antenna and process seal antenna) may generate

an ignition-capable level of electrostatic charge under extreme conditions. Therefore, when the
antenna is used in a potentially explosive atmosphere, appropriate measures must be taken to
prevent electrostatic discharge.
Operation
Operation
). Refer to the safety messages listed at the beginning of each section before
Operation
October 2018
149