Continuous Drive Pulse Output - ICP DAS USA I-8092F User Manual

A.2.5 Continuous Drive Pulse Output
When the continuous driving is performed, it will drive pulse output in a specific speed until stop
command or external stop signal is happened. The main application of continuous driving is:
home searching, teaching or speed control. Two stop commands are for stopping the continuous
driving. One is "decelerating stop", and the other is "sudden stop". Four input pins, IN3~IN0, of
each axis can be connected for external decelerating and sudden stop signals. Enable / disable,
active levels and mode setting are possible.And it is necessary to set the following parameters:
Range: R
Initial Speed: SV (PPS)
Driving Speed: V (PPS)
Acceleration: A (PPS/Sec)
ICPDAS
Fig. A-12 Continuous driving
92
I-8092F Software User Manual