Constant Speed Driving - ICP DAS USA I-8092F User Manual

A.2.6 Constant Speed Driving
When the driving speed command set in I-8092F is lower than the initial speed, the acceleration
/deceleration will not be performed, instead, a constant speed driving starts. If the user wants to
perform the sudden stop when the home sensor or encoder Z-phase signal is active, it is better
not to perform the acceleration / deceleration driving, but the low-speed constant driving from the
beginning. For processing constant speed driving, the following parameters will be preset
accordingly.
Range: R
Initial Speed: SV
Drive Speed: V (Just set one of SV and V can be attained the effect)
Output Pulse Numbers: P (Only applicable for the fixed pulse driving)
ICPDAS
Fig. A-13 Constant speed driving
93
I-8092F Software User Manual