Pulse Output Command; Signal Types - ICP DAS USA I-8092F User Manual

A.2 Pulse Output Command
A.2.1 Signal Types
I-8092F has two modes for pulse output command: One is fixed-pulse command output mode;
the other is continuous pulse command output mode. User can choose the modes by setting the
specific registers. There are two ways to choose the desired pulse mode: a) adjusting hardware
jumper, and b) setting registers by software programming. The output pulse command modes are
showing in Table 2-2. Moreover, the detail illustration for the pulse modes are shown in Fig. A-1~
Fig. A-6.
ICPDAS
Fig. A-1 CW/CCW Input mode 1
Fig. A-2 CW/CCW Input mode 2
88
I-8092F Software User Manual