Safety Features - Stratasys Objet30 User Manual

Safety

Safety Features

UV screen
Cover interlock switch
2–2
Objet 3D printers are designed to comply with CE and FCC standards.
They are equipped with the following safety features:
Cover interlock The power supplied to the UV lamp and the
switch motion motors is turned off when the cover is
opened.
WARNING: Do not defeat (override) the
interlock switch. Doing so could result in
serious personal injury. If the interlock switch
does not function correctly, do not use the
printer, and contact your service provider.
Cover lock The cover is locked while the printer is
working. It is released when the printer reverts
to pause or stop mode.
WARNING: Do not defeat (override) the
safety lock. Doing so could result in serious
personal injury.
If the safety lock does not function correctly, do
not use the printer, and contact your service
provider.
UV screen The transparent section of the cover blocks
harmful UV radiation, allowing the operator to
view the model as it is being made.
Circuit breaker The power to the printer is turned off in case of
electrical overcurrent.
Note: The circuit breaker is only accessible to
service personnel.
Grounded chassis The chassis of the printer is grounded, to
prevent electrical shock.
Note: The power outlet must be properly
grounded, in accordance with the local
electric code, to provide this protection.
Figure 2-1: Front and back views of the Objet30 printer
If the Objet 3D printing system is not used as specified in this guide, the
safety features may not provide adequate protection.
Circuit breaker
DOC-24333 Rev. A