Operating & Maintaining the Objet30 3D Printer
Changing the Model Material
6–12
Before producing models using a different type of model material than is
currently installed, run the Material Replacement Wizard to flush the print
block and feed tubes.
You should carefully plan printing models with different model materials to
avoid unnecessary waste of the materials currently loaded. The amount of
material flushed depends on the flushing cycle chosen and if you are
replacing one or both materials. For details, see page 13.
To replace the model material:
1. Start the Material Replacement Wizard from the Options menu.
Figure 6-11: Starting the Material Replacement Wizard from the Options menu
2. In the opening screen, click
3. If the printer cover is not closed, a screen appears instructing you to
close the cover. Confirm that it is closed and click
4. In the Compartment Selection screen, select the cartridge(s) you want to
replace, and click
Next
Figure 6-12: Compartment Selection screen
.
Next
.
.
Next
DOC-24333 Rev. A