Sanyo VCC-XZN600P Instruction Manual page 53

1
Use the / button to select [ALARM OUT], and press the SET button.
The ALARM OUT screen appears.
2
Use the / button to select [OUTPUT], and use the
output.
Available settings:
ON: Outputs the alarm signal.
OFF: Does not output the alarm signal.
REMOTE: Outputs the alarm signal by remote operation.
When selecting "REMOTE", "MANU" is available for [ALARM TIME] enabling remote operation of the
alarm output using an external device.
Selecting [AUX6-ON] enables remote operation, and selecting [AUX6-OFF] disables remote
operation.
While the alarm is output using remote operation, the alarm signal will not be output automatically
even when the alarm condition is detected.
3
Use the / button to select [POLARITY], and use the
alarm output signal.
Available settings:
NO (Normal Open): Normally open so closed condition is detected as output.
NC (Normal Close): Normally closed so open condition is detected as output.
4
Use the / button to select [ALARM TIME], and use the
which the alarm signal is output.
Available settings: 2S, 5S, 10S, 15S, 20S, 30S, 45S, 1M, 2M, 3M, 4M, 5M, MANU (S: seconds, M: minutes)
5
Select [MENU] and choose "BACK" or "END" to complete the setting.
/ button to enable/disable the alarm
/ button to select the polarity for the
/ button to set the duration for
53 / 153