Sanyo VCC-XZN600P Instruction Manual page 124

Set the image transfer mode to "HTTP".
Sets image conditions for live video image and normal recording.
RESOLUTION
PICTURE QUALITY
Sets image conditions for the alarm recording.
1
RESOLUTION
PICTURE QUALITY
Select the [BUFFER SIZE] option for specifying the buffering capacity for recording each alarm image.
2
According to the value you select, perform the following settings:
One alarm image set containing both the pre- and post-alarm images is stored in the camera, and then the
alarm image set is transferred one by one to the "VA-SW3050" software.
PRE/POST Configures the recording capacity ratio between the pre- and post-alarm image recordings.
RATE Configures the recording rate for the alarm image.
If [PRE/POST] is set at other than "0%/100%", the [LIVE/NORMAL RECORD (
changed.
When the alarm is detected, only the post-alarm images will be transferred to the "VA-SW3050" software.
The transfer speed depends on the network environment.
DURATION Specifies the duration of each alarm image to transfer (During this duration, no other alarms can be processed for
transferring the alarm image).
After completing the settings, click this button to confirm the settings.
To restore the original settings, click the [CANCEL] button before clicking the [SET] button.
Displays the [HELP] screen in a separate window.
124 / 153
)] setting cannot be
2