Sanyo VCC-XZN600P Instruction Manual page 40

1
Use the / button to Choose "ADJ" and press the SET button.
The LEVEL SETTING screen appears.
2
Use the / button to select the level setting item (
the luminance level at which switching occurs.
1 [COLOR→B/W]
Sets the luminance level at which switching occurs from the color mode to the black/white mode.
Available settings: 1 to 7 (Switching occurs in darker conditions as the luminance value increases.)
2 [B/W→COLOR]
Sets the luminance level at which switching occurs from the black/white mode to the color mode.
To prevent hunting in infrared (IR) lighting, set the two luminance settings to widely different values.
Available settings: 1 to 7
(Switching occurs in darker conditions as the luminance value increases. Changing this setting also
changes the other setting to retain the difference.)
3
Use the / button to select [BURST] and use the
If connected to a peripheral device like a frame switcher, the camera may produce distorted images (or "burst")
when switching between the color and black/white video modes.
This phenomenon can be corrected by inserting a color burst signal.
Normally, set [BURST] to "OFF".
Available settings:
ON: Inserts a burst signal.
OFF: Does not insert a burst signal.
4
Use the / button to select [FOCUS] and use the
compensation mode.
Normally, set the focus compensation mode to "2". However, if the target gets out of focus, set this to "1".
Available settings:
1: Use this mode if the camera is used under near-infrared lighting.
2: Use this mode if the camera is used under natural sunlight or normal lighting.
5
Select [MENU] and choose "BACK" or "END" to complete the setting.
1
Use the / button to select [DAY/NIGHT], use the
the SET button.
The D/N SETTING-COLOR screen appears.
or ) and use the
1 2
/ button to turn ON/OFF the burst signal.
/ button to choose the focus
/ button to choose "COLOR", and press
40 / 153
/ button to adjust