Sanyo VCC-XZN600P Instruction Manual page 36

2
Use the
press the SET button.
This sets a mask at the position where you moved the mask pattern. A new mask pattern starts blinking.
Repeat this step to set masks as many as you want.
To delete a mask, move the mask pattern over it and press the SET button.
3
When finished setting masks, use the
the screen and press and hold the
The [PRESET] and [MENU] items appear on the screen.
4
Select [MENU] and choose "BACK" or "END" to complete the setting.
You can adjust the sensitivity of motion sensor to prevent unwanted detection.
1
Use the / button to select [SENSITIVITY] and press the SET button.
The SENSITIVITY screen appears.
2
Use the / button to select one of the following sensitivity items and use the
adjust the detection level.
For all items, the sensitivity decreases as you increase the value.
MOVE (Motion sensitivity):1 to 10
1
Set a larger value to prevent the detection of subtle movements, such as those caused by a breeze.
Y-LEVEL (Brightness level): 1 to 10
2
Set a larger value to prevent unwanted detection due to noise in a dark image.
Y-DIFFER (Brightness difference): 1 to 10
3
Set a larger value to prevent the motion sensor from responding to the switching ON/OFF of lighting.
DURATION (Detection interval): 1 to 60
4
Set a larger value to prevent the detection of fast-moving objects.
To test the sensitivity settings, select [TEST] using the
button.
A detection pattern will appear in any area where a motion is detected. Adjust the settings as
necessary.
3
Select [MENU] and choose "BACK" or "END" to complete the setting.
buttons to move the mask pattern over the light source you want to mask and
button for approximately three seconds.
button to move the mask pattern to the bottom area of
/ button and choose "ON" using the
36 / 153
/ button to
/