Sanyo VCC-XZN600P Instruction Manual page 110

The MAC address of the camera is displayed automatically. (It cannot be changed.)
When the [IP ADDRESS] setting is "DHCP", select the method for configuring the DNS server address.
FIX Manually configure the IP address.
→Enter the IP address.
DHCP Automatically allocates the IP address.
When the [DNS] setting is "FIX", enter the DNS server address.
Select "ON" when you want to use the SSL encryption for the video signal.
If you see the warning message pop up, saying "This page contains both secure and nonsecure
items...", you can make it undisplayed by performing the following steps:
Open the [Internet Options] dialog box on Internet Explorer, click the [Security] tab and click the
[Custom Level...] button to open the [Security Settings] dialog box, and then enable "Display mixed
content".
The message will not pop up again.
The default value depends on the preferences specified in the [SSL] setting above.
SSL (OFF) 80
SSL (ON) 443
Set a port number between 1 and 65535, making sure that it doesn't duplicate the following values.
[UDP (Unicast) PORT] or [UDP (Multicast) PORT] on the [CODEC/STREAMING SETTINGS]
screen
49152 (reserved for UPNP port)
Specify the login password according to each user name (guest/admin).
When you enter a blank "guest" password (no password is specified), the authentication process for
accessing the camera will be omitted.
Select the data transfer speed in consideration of the network environment.
After completing the settings, click this button to confirm the settings.
To reflect the settings, use the Close button to terminate the camera connection, and then access the camera
again.
To restore the original settings, click the [CANCEL] button before clicking the [SET] button.
110 / 153