Sanyo VCC-XZN600P Instruction Manual page 49

1
Use the / button to select [ALARM] in the main menu, and press the SET button.
The ALARM screen appears.
2
Use the / button to select [ALARM IN], use the
number, and press the SET button.
The ALARM IN screen corresponding to the selected alarm input number (1 or 2) appears.
Available options: 1, 2
When the alarm input is used as the external control input of the DAY/NIGHT function, "D/N" appears
in the top right of the screen.
In this case, settings other than [POLARITY] cannot be made.
When [EXT ALARM] for [DAY/NIGHT (COLOR)] is set to "OFF", "D/N" disappears.
3
Use the / button to select [POLARITY], and use the
the alarm input signal.
Available settings:
NO (Normal Open): Normally open so closed condition is detected as input.
NC (Normal Close): Normally closed so open condition is detected as input.
4
Use the / button to select [ACTION], and use the
alarm is detected.
Available settings:
OFF: Does not perform any actions.
ZOOM: Zooms into the video at the specified magnification power.
To use this setting, set the zoom magnification power ([RATIO]) and the display duration ([ZOOM TIME]).
CAM1/CAM2: Uses the operating conditions you configured for Camera 1 or Camera 2 in [CAMERA] on
the main menu to monitor surveillance points.
To use this setting, select whether or not to return to the previous operating conditions upon completion of
an alarm action (in [RETURN] under the item [ACTION]).
/ button to choose an alarm input
/ button to choose the polarity for
/ button to select the action after the
49 / 153