Sanyo VCC-XZN600P Instruction Manual page 52

Available settings:
AND: Both the motion sensor and the external device detect an alarm condition.
OR: Outputs an alarm signal if the motion sensor detects an alarm condition or an external alarm input is
received.
5
Use the / button to select [ALARM OUT], and use the
alarm output.
Available settings:
OFF: Does not output the alarm signal.
ON: Outputs the alarm signal.
6
Use the / button to select [LINE OUT], and use the
output to the communication line.
Available settings:
OFF: Does not output the alarm signal.
ON: Outputs the alarm signal.
7
Use the / button to select [DURATION], and use the
duration.
When an alarm is detected, another alarm signal will not be input until the duration specified in this setting has
passed.
Available settings: 5S, 10S, 15S, 20S, 30S, 45S, 1M, 2M, 3M, 4M, 5M (S = seconds, M = minutes)
The alarm disable duration is applied to the external device which has the same alarm input number.
When an input from another alarm input number is detected, the alarm will be received even in the
alarm disable duration.
When multiple alarm inputs are received simultaneously, the input whose alarm number is smaller
precedes the others.
8
Select [MENU] and choose "BACK" or "END" to complete the setting.
/ button to enable/disable the
/ button to enable/disable the alarm
/ button to choose the alarm disable
52 / 153