Figure 6-33: Releasing Right Tab; Figure 6-34: Removing Bottom Cover; Figure 6-35: Removing Base Plate Dummy End; Figure 6-36: Cutting Dummy End In Half - NEC Xen alpha Installation Manual

4.
5.
6.
7.
Installation Manual, Chapter 6 – Installing DTU-Type Multiline Terminals
November 2003, A6-506000-642-01(8508), Release 6.0
Lightly press right side of leg shown as B in Figure 6-33: Releasing Right Tab,
insert flat head screwdriver at C and Press straight down until other tab unlocks.

Figure 6-33: Releasing Right Tab

Open and remove Bottom Cover by rotating counterclockwise as shown in Figure
6-34: Removing Bottom Cover.

Figure 6-34: Removing Bottom Cover

If an adapter is being installed, press tabs A and B to remove the dummy end from
the base plate as shown in Figure 6-35: Removing Base Plate Dummy End.

Figure 6-35: Removing Base Plate Dummy End

Cut the dummy end in half as shown in Figure 6-36: Cutting Dummy End in Half.

Figure 6-36: Cutting Dummy End in Half

143