Connecting The Cables On The Cta-Ba Unit; Installing The Driver On The Pc; Figure 6-53: Attaching The Unit To The Multiline Terminal; Figure 6-54: Connecting The Rs-232C Cable To The Cta-Ba Unit On The Multiline Terminal - NEC Xen alpha Installation Manual

3.
4.

Connecting the Cables on the CTA-BA Unit

Connect the RS-232C cable from the computer to the connector on the CTA-BA Unit
as shown in Figure 6-54: Connecting the RS-232C Cable to the CTA-BA Unit on the
Multiline Terminal.

Installing the Driver on the PC

Using the setup disk provided with the CTA-BA Unit install the driver onto your PC.
Refer to the CTA installation Guide for instructions on installing CTA setup disks.
Installation Manual, Chapter 6 – Installing DTU-Type Multiline Terminals
November 2003, A6-506000-642-01(8508), Release 6.0
Plug the unit into the receptacle connector inside the base plate on the Multiline
Terminal. Refer to Figure 6-53: Attaching the Unit to the Multiline Terminal.

Figure 6-53: Attaching the Unit to the Multiline Terminal

Close the base plate.

Figure 6-54: Connecting the RS-232C Cable to the CTA-BA Unit on the Multiline Terminal

155