Lcd8B Com Pin Control Register 0; Lcd8B Interrupt Flag Register; Lcd8B Interrupt Enable Register - Epson S1C17W14 Technical Manual

Bits 1–0 DSPC[1:0]
These bits control the LCD display on/off and select a display mode. For more information, refer to
"Display On/Off."

LCD8B COM Pin Control Register 0

Register name Bit
LCD8COMC0 15–8 –
7
6
5
4
3
2
1
0
Bits 15–8 Reserved
Bits 7–0 COMxDEN
These bits configure the partial drive of the COMx pins.
1 (R/W): Normal output
0 (R/W): Off waveform output

LCD8B Interrupt Flag Register

Register name Bit
LCD8INTF 15–8 –
7–1 –
0
Bits 15–1 Reserved
Bit 0 FRMIF
This bit indicates the frame interrupt cause occurrence status.
1 (R): Cause of interrupt occurred
0 (R): No cause of interrupt occurred
1 (W): Clear flag
0 (W): Ineffective

LCD8B Interrupt Enable Register

Register name Bit
LCD8INTE 15–8 –
7–1 –
0
Bits 15–1 Reserved
Bit 0 FRMIE
This bit enables the frame interrupt.
1 (R/W): Enable interrupt
0 (R/W): Disable interrupt
S1C17W14/W16 TECHNICAL MANUAL
(Rev. 1.2)
Bit name Initial
0x00
COM7DEN 1
COM6DEN 1
COM5DEN 1
COM4DEN 1
COM3DEN 1
COM2DEN 1
COM1DEN 1
COM0DEN 1
Bit name Initial
0x00
0x00
FRMIF 0
Bit name Initial
0x00
0x00
FRMIE 0
Seiko Epson Corporation
Reset R/W
– R –
H0 R/W
H0 R/W
H0 R/W
H0 R/W
H0 R/W
H0 R/W
H0 R/W
H0 R/W
Reset R/W
– R –
– R
H0 R/W Cleared by writing 1.
Reset R/W
– R –
– R
H0 R/W
18 LCD DRIVER (LCD8B)
Remarks
Remarks
Remarks
18-19