Epson S1C17W14 Technical Manual page 336

Code No. Page
412910301 18-4
18-6
22-1
22-1
22-4
22-7
22-9
23-1 to 2
24-1 to 2
AP-A-11
18.4.3 External Voltage Application Mode 2
Corrected the description.
In this mode, the LCD drive voltage V
internally generated.
18.5.2 Display On/Off
Added a note.
Note: When "Display off" is selected, the electric charges of V
following procedure.
...
To turn the display on again, perform the above procedure in the reverse order.
22.1 Absolute Maximum Ratings
Modified the characteristics table.
V : #RESET was added to the condition.
I
22.2 Recommended Operating Conditions
Added "(V = 0 V) *1" and the following annotations:
SS
*1 The potential variation of the V
ground potential of the MCU mounting board while the Flash is being programmed, as it affects the
Flash memory characteristics (programming count).
*6 The component values should be determined after evaluating operations using an actual mounting
board.
Modified the characteristics table.
V : Condition = When an external voltage is applied V
C1-3
C : *5 was deleted.
VPP
22.4 System Reset Controller (SRC) Characteristics
Reset hold circuit characteristics
Modified the characteristics table.
t : Min. = 0.5 ms, Max. = 0.9 ms
RSTR
22.6 Flash Memory Characteristics
Added an annotation.
*1 The potential variation of the V
ground potential of the MCU mounting board while the Flash is being programmed, as it affects the
Flash memory characteristics (programming count).
22.9 UART (UART) Characteristics
Modified the characteristics table.
U : Max. = 115,200 bps (V
BRT2
23 Basic External Connection Diagram
Modified the figures.
C was changed to that must always be connected.
VPP
24 Package
A JEITA name was added to the package name.
Appendix A List of Peripheral Circuit Control Registers
PDIOEN (Pd Port Enable Register)
Modified the register table.
PDIOEN register: PDOEN[4:3], [1:0] → PDOEN[4:0]
Contents
or V is applied from outside the IC and other voltages are
C1 C2
voltage should be suppressed to within ±0.3 V on the basis of the
SS
voltage should be suppressed to within ±0.3 V on the basis of the
SS
= 1.6 to 3.6 V), 57,600 bps (V
DD
(or V ) must be discharged in the
C4 C3
≤ V ≤ V , V ≤ V
C1 C2 C3 C1 DD
= 1.2 to 1.6 V)
DD