Basic Configuration Overview; Configure Network Interfaces; Figure 3-15: Configuration Flow - Baicells Nova846 Installation Manual

Outdoor 8x5w two-carrier tdd enodeb

Hide thumbs Also See for Nova846:

Table of Contents

Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide

3.8.3 Basic Configuration Overview

Figure 3-15 indicates four main steps for basic configuration: network interfaces, management

server address, quick settings pertaining to key LTE parameters, and the carrier setting.

The network interfaces defined as part of the initial, basic setup include the WAN/LAN/VLAN

interfaces, DHCP, and the Local Gateway (LGW) mode.

3.8.4.1 WAN/LAN

Go to the Network > WAN/LAN menu (Figure 3-16) to configure the WAN interface. The WAN

interface is an external communication portal (Internet connection) between the eNB's Network

Management System (NMS) – in most cases, the CloudCore OMC – and the Mobility Management

Entity (MME). If not using CloudCore, the eNB's NMS may be a Local OMC or the LTE NMS.

Although not shown in the Network > WAN/LAN sub-menu label, the WAN interface supports the

configuration of multiple Virtual Local Area Networks (VLANs), which can be used by single-carrier

eNBs only. The Network > WAN/LAN fields are described in Table 3-1.

Table of Contents