Table of Contents
Advertisement
Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide
3.8.6 Configure Quick Settings
Under the BTS Info > Quick Setting window (Figure 3-20) are several important fields you must
configure and/or verify, including several key parameters to support CBRS SAS when SAS is enabled
in the LTE Setting > SAS Settings sub-menu.
First, if the operator is using the Baicells CloudCore EPC, you must enter a fixed Public Land Mobile
Network (PLMN) and MME IP address:
PLMN = 314030
•
MME IP = 10.3.0.9 and 10.5.0.9
•
Do not change these settings except when connecting to a Local (private network) EPC or different
vendor's EPC.
Second, if you are not planning to use CBRS SAS, you must enter the operator's planned settings
for Band, Bandwidth, EARFCN, Cell ID, PCI, TAC, etc. If you are planning to use CBRS SAS, the SAS
vendor will determine the parameters for Band, Bandwidth, Frequency, and Power Modify.
However, you can configure your preferences for these settings by selecting a preferred Frequency
Selection Logic, Preferred Bandwidth, Preferred Power, and Preferred Frequency. All of these
preferences are explained in the
If you are testing the eNB in a lab environment, turn the power down as low as it will go under the
Power Modify field.
NOTE: The Nova846 does not support SFA = 0.
For a description of all the eNB Quick Setting fields, refer to the
Guide.
.
SAS Deployment Guide
35
Nova846 eNodeB Configuration
Advertisement
Table of Contents
