Table of Contents
Advertisement
Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide
If the Connect Via field is set to DHCP and the LGW function is ON
Type field must be modified. The IP address of the eNB will be changed due to the MAC address
being changed. Therefore, modify the router server at the same time.
The LAN configuration is used only as a local maintenance port during initial eNB setup and basic
configuration; it is not used during normal eNB operation. Enter the IP address for the local
network connection. The default IP address for the LAN interface is 192.168.150.1 and the default
IP address for the and subnet mask address is 255.255.255.0.
NOTE: If the LAN IP address is changed, the eNB will reboot, and you will have to log in to
the GUI again.
Figure 3-16: WAN/LAN
Table 3-1: WAN/LAN
Field Name
WAN Pane
Connect Type
Description
Select Auto, Copper, or Fiber type of connection to the WAN:
• Auto: Automatically matches an optical or electrical port based on the
hardware connection
• Copper: RJ-45 (electrical) port
• Fiber: optical port
29
(section
3.8.4.2), the Connect
Advertisement
Table of Contents
