Table of Contents
Advertisement
Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide
3.8.1 Launch the eNB GUI
Follow the steps below to connect to the Nova846 GUI.
Step 1:
Use an Ethernet cable to connect the eNB DATA MGMT ETH port to the local
network routed to the Internet. The DATA interface is set to DHCP client by default.
Optionally, you can plug a Personal Computer (PC) directly into the eNB DATA MGMT
ETH port. On your PC you will need to assign a static IP address within the
Management (MGMT) subnet. The default IP address for the MGMT interface is
http://192.168.150.1/24.
Step 2:
Open a Web browser, and enter the following IP address: http://192.168.150.1.
Step 3:
At the login screen (Figure 3-13), enter the default user name (admin) and
password (admin) and click on Login to open the home page.
Figure 3-13: GUI Login
The home page is the Basic Setting > Basic Info menu, which reports the current eNB status
(Figure 3-14). In
section
Figure 3-14: Home Page
3.8.9, you will use this page to confirm that the eNB is active.
26
Advertisement
Table of Contents
