Upgrade Firmware - Baicells Nova846 Installation Manual

Outdoor 8x5w two-carrier tdd enodeb

Hide thumbs Also See for Nova846:

Table of Contents

Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide

Optionally, you may want to:

1. Change the login password.

2. Confirm the firmware version is the latest available from Baicells; upgrade if needed.

Firmware upgrades can be found at Baicells.com > Support > Firmware. See

for detailed instructions regarding firmware upgrades.

3. Set the Network Timing Protocol (NTP).

For help, refer to the

CloudCore Configuration & Network Administration

3.8.2 Upgrade Firmware

To ensure you are using the most recent software version before configuring the eNB, follow the

steps below.

3.8.2.1 Upgrade Firmware from the eNB GUI

1. Download the most recent firmware file from Baicells.com > Support > Firmware, and save

on local computer.

2. Go to System > Upgrade, and select whether to preserve the current settings.

3. Click Select File, and navigate to the firmware file saved on local computer.

NOTE: The file type is *.IMG

4. Click Upgrade Now.

5. In the pop-up window click PROCEED.

6. The base station reboots after approximately three minutes.

7. On the BTS Info > Basic Info page, the upgraded version is displayed in Software Version.

3.8.2.2 Upgrade Firmware from the OMC

1. Go to eNB > Upgrade > Upgrade&Rollback.

2. Select the correct Product Type from the list.

3. Select the checkbox next to the eNB(s) you want to upgrade.

4. In the New Task window, select the Upgrade Type.

5. In the eNB section, select the checkbox(es) next to the eNB(s) you want to upgrade.

6. Next to File List, select/deselect Retain Configuration. Under Select, choose the software

version by clicking in the empty cell (a blue checkmark will appear).

7. Choose the Execute Type, which determines when the upgrade will occur.

8. Select OK.

Section 3.8.2

Guide.

Table of Contents