Figure 3-17: Lgw = Router; Table 3-2: Lgw = Router Fields - Baicells Nova846 Installation Manual

Outdoor 8x5w two-carrier tdd enodeb

Hide thumbs Also See for Nova846:

Table of Contents

Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide

Field Name

Prefix

Vlan ID

3.8.4.2 LGW

The LGW setting must be configured when using the Baicells CloudCore EPC. Refer to Figure 3-17

and Table 3-2. You must reboot the eNB when you make changes to these settings.

Figure 3-17: LGW = Router

Field Name

LGW

LGW Mode

Description

This parameter displays if "connect via" protocol type selected is IPv6 Static

IP. Used to set the IPv6 address' prefix for the WAN interface.

Used when the operator needs to transmit multi-types of data through

separate channels via IP addresses for the WAN interface through VLAN. The

VLAN IDs should be unique numbers not identical to any other VLAN. The

range is 1 to 4094. Avoid using "12", which is commonly used by the LAN

interface.

Description

On or Off

Select an option:

NAT: Packages from the internal network to the external network need

Network Address Translation

Router: Select optimized route from the routing table

(Figure 3-18, section

3.8.4.3)

Bridge: Transfer in the data link layer

Table of Contents