Table of Contents
Advertisement
Aurora243 Outdoor 2x10W TDD gNodeB Installation Guide
Initial Configuration
4.
4.1 Configure Basic Parameters
After installing and testing the Aurora243 gNB, Baicells recommends configuring the gNB without enabling
HaloB or SAS to verify that the new eNB unit is operational. Once it is confirmed to be operational, you
can refer to the appropriate configuration guide(s) for the operating mode you plan to use.
NOTE: For all GUI menus and fields, refer to the following documents on the Baicells website:
Baicells.com > Resources > Documents.
•
CloudCore Configuration & Network Administration Guide (OMC/BOSS)
•
CPE Configuration Guides
4.1.1.1 Network Connection Requirements
Before initial configuration, verify that the following network connections of Aurora243 gNB, as shown in
(Figure 4-1) are connected successfully.
Aurora243 gNB connects to the core network through the optical backhaul interface (OPT).
•
ETH interface is the management port used for debugging.
•
•
The ANT0 and ANT1 ports must be connected to the external RF antennas.
Connect the GPS interface to the external GPS antenna.
•
Figure 4-1: Network Connection
30
Advertisement
Table of Contents
