Baicells Nova846 Installation Manual page 30

Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide
Field Name
DNS Mode
DNS Address 1
DNS Address 2
Link Speed Negotiated
Allow management
access over WAN
Internet/WAN Pane
Enabled
Connect Via
Current IP
Option60
Subnet Mask
Gateway
Description
Select DNS mode:
• Auto: Selects DNS automatically. The DNS's current IP address displays if
Auto is selected.
• Manual: Set the DNS server manually if the IP address is a static one. The
next DNS IP address must also be set if Manual is selected.
This parameter, which is DNS IP address 1, displays if DNS mode is set to
Manual.
This parameter, which is DNS IP address 2, displays if DNS mode is set to
Manual.
Select negotiated link speed. Auto negotiation, 100M (Mb/s), and 1000M are
supported.
Enable or disable the LMT connection through the WAN port.
Indicates if the interface is enabled or not. The eNB supports the
configuration of four IP addresses at most.
Options for the interface protocol used by the WAN interface:
• DHCP
• Static IP
• IPv6 DHCP
• IPv6 Static IP
NOTE: See detailed descriptions of each connection type in
the section introduction above. The DHCP protocol is
recommended. The displayed fields depend on which
protocol is selected.
The WAN interface IP address. The IP address is acquired automatically if
"connect via" protocol type selected is DHCP.
This parameter displays if "connect via" protocol type selected is DHCP.
This parameter displays if "connect via" protocol type selected is Static IP.
This is the IP address' subnet mask address.
This parameter displays if "connect via" protocol type selected is Static IP.
Used to set the default gateway's IP address.
30