Basic Configuration; Log In & Change Password; Figure 5: First Login - Baicells Atom ID0406-6.5 User Manual

2. Connect the cables (per previous Figure 3), and power on:
a. LAN: Connect one end of the RJ-45 Ethernet cable to the LAN interface on the back of the
unit. Connect the other end to a computer or other LAN device.
b. Power: Connect the DC-5V power adaptor to the power connector on the back of the unit.
Plug the other end into an electrical outlet.
c. Turn the power switch to ON.

6 Basic Configuration

Reference: CPE Configuration Guide
The CPE comes preloaded with a Graphical User Interface (GUI) to configure the device. The GUI screens
for CAT4 and CAT6/7 CPEs look different, though both contain many of the same types of settings. This
manual covers both GUIs and points out where there are differences.
The basic configuration settings allow you to get the CPE up and running, i.e., connected to the Internet, in
order to verify operation. Other features as well as more in-depth information about the CPE GUIs are
covered in the document referenced above.
6.1 Log in & Change Password
With your computer connected through Ethernet to the CPE:
1. Open a Web browser, and enter http://192.168.150.1.
NOTE: If the address does not open the GUI, try
for older generation UEs.
2. Upon first login, you may be prompted to change your password (Figure 5).

Figure 5: First Login

When you click on OK, you will be taken to the System > Account window (Figure 6). Enter a
password using 5 to 16 characters (upper/lower case letters, numbers, and special characters). For
CAT4, click on SAVE & APPLY. For CAT6/7, click Apply.
For CAT6/7, in the System > Account window you can change the lockout time, i.e., if there is no
activity on the CPE for this amount of time, users will be logged off. The default is 300 seconds (five
minutes), and the maximum is 65535 seconds (~18 hrs). Click on Apply to save.
http://192.168.254.1 or http://192.168.1.1. These were used
5