Table of Contents
Advertisement
Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide
About This Document
This document is intended for personnel who will be installing the Baicells Nova846 Outdoor 8x5W
eNodeB (eNB) product. The product overview is followed by the procedures for properly installing,
performing basic configuration, and verifying the eNB is operational. Please be advised that only
personnel with the appropriate electrical skills and experience should install this device. This
document is based on software version BaiBU_DNB4_2.2.7. The Nova846 model numbers are:
sBS71040, Band 41 (2496 MHz–2690 MHz)
•
•
sBS71010, Band 48 (3550 MHz–3700 MHz)
Terms used in this document or related to Long-Term Evolution (LTE) are listed in alphabetical order
and described in
Acronyms and
Documents.
Copyright Notice
Baicells Technologies copyrights the information in this document. No part of this document may
be reproduced in any form or means without the prior written consent of Baicells Technologies.
Disclaimer
The information in this document is subject to change at any time without notice. For more
information, please consult with a Baicells technical engineer or the support team. Refer to the
"Contact Us" section below.
Disposal of Electronic and Electrical Waste
Pursuant to the WEEE EU Directive, electronic and electrical waste must not be disposed
of with unsorted waste. Please contact your local recycling authority for disposal of this
product.
Revision Record
Date
Version
8-Feb-2023
1.03
29-Dec-2022
1.02
7-Dec-2022
1.01
Abbreviations, which can be found at Baicells.com > Resources >
Description
Updated packout figure in
section 2.1
Updated procedures in
section 3.4.3
for connecting RF
cables to antenna interfaces
Initial release for
BaiBU_DNB4_2.2.7 (Nova846)
2
SMEs/Contributors
Blake Volk
Erik Randall, Blake Volk
Warren Lai, Abel Lamas,
Sonny May, Kevin Shen, Blake
Volk
Author/Editor
Kathy Clark
Kathy Clark
Kathy Clark
Advertisement
Table of Contents
