Checking The Image Quality; Setting The Date And Time; Checking The Network Connection; Connecting To The Telephone Line - Canon LASER CLASS 810 Service Manual

2)Connect the power cord [1] into the AC inlet.

2.2.7 Checking the Image Quality

1)Plug the power cord [1] into the outlet, and then turn on the main power
switch [2].
Use the specified power supply (rated voltage -/+10% and rated current).
[2]
2)A country/region setting screen appears by the model. Make choices ac-
cording to the environment where the machine is used.
3)Place a document on the document pickup tray, take a copy of it by sup-
plying paper from the cassette or manual feed tray, and check the printed
image. Also perform the following checks:
- Check whether abnormal sound is heard.
- Check the printed images at all preset magnifications.
- Check whether the document is copied normally on the specified
number of sheets.

2.2.8 Setting the Date and Time

1)Press the additional functions key to display the user mode screen.
2)Select "TIMER SETTINGS" and then press the OK.
3)Select "DATE&TIME SETTING".
4)Enter the current date and time with the ten keys.
5)Press the OK to allow the entered date and time to take effect.

2.2.9 Checking the Network Connection

1)Press the following keys to display the service mode screen:
> 2 Key > 8 Key >
[1]
F-2-24
[1]
F-2-25
2) Select "# REPORT" using the left and right cursor keys, and then press the
OK key.
3) Select "REPORT OUTPUT" using the left and right cursor keys , and then
press the OK.
4)Select "SPEC LIST" using the left and right cursor keys , and then press
the OK.
5) When "SPEC REPORT" is displayed, check that "NETWORK" of "ACT-
IBAT FUNCTION" is set to ON.
6) Contact the system administrator of the customer to make network set-
tings.

2.2.10 Connecting to the Telephone Line

1)Turn off the main power switch of this machine.
2)Connect modular plug at either end of the modular cable [1] to the modular
jack (LINE) at the back of the machine, and connect the other modular
plug to the modular jack on the wall.
Use the modular cable supplied with the machine. If you use another
modular cable, its length must be within 3 m.
0016-7410
3)Turn on the main power switch.
4)Make the minimum settings required to use the fax feature.
a. Registering the User Telephone Number
Additional functions key > [Communications Settings] > [User Settings
(Fax Settings)] > [Uit Telephone #] > Enter the fax No. > [OK]
b. Selecting the Telephone Line Type
Additional functions key > [Communications Settings] > [User Settings
(Fax Settings)] > [Tel Line Type] > Select [Pulse] or [Tone]. > [OK]
5) Conduct a communication test to check the fax feature is implemented
properly.
5-1) Using ten keys, enter the telephone number of a called party who
allows you to conduct the communication test. Send a test
document to check for normal transmission. If the test document
cannot be sent normally, check whether the set telephone line type
is the same as the type of the telephone line connected to this
machine.
5-2) Ask the called party to send a test document to your to check for
normal reception.
0016-7382
0016-9968
Chapter 2
F-2-26
0016-9969
[1]
2-9